ADIC DLT 7000 Dokumentacja Pobierz pdf (Strona 21)

Installation 11

Installing in the Rack

Perform the following procedure to install your T5 Enclosure in a standard 19" rack:

1. Remove the hardware components from the accessories bag.

2. Verify that the following components are included:

Quantity Component

10 Captive nut (cage nut), 10-32, slip-on

10 Captive nut (cage nut), 10-32, snap-in

12 Screw, Phillips, 10-32 x ½”

12 Washer, flat, # 10

12 Washer, lock, # 10

3. Locate the left- and right-side rack mount support brackets.

The rack mount support brackets are secured to your racks rear vertical rails with four 10-32 x ½” Phillips

screws and 10-32 cage nuts.

4. Install two cage nuts in each of the racks rear vertical rails (as shown below) by either snapping them

into, or slipping them into the holes in each rail. The cage nuts need to be vertically spaced to secure

each support bracket using a lower and an upper mounting slot.

Front of Rack

Rear Vertical Rails

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Brak uwag

ADIC DLT 7000 Dokumentacja Strona 21